DIY Secondary Glazing Hinged Pane Kits

The DIY Secondary Glazing  hinged pane system makes up to give one hinged pane. It may be hinged from the side or from the top to match your window. The DIY Secondary Glazing  hinged pane system fits directly to the flat wooden face of the window surround provided it is at least 32mm (1 1/4″) wide to accept the fittings.

Where two hinged panes are used on the same window , allow at least 50 mm ( 2″ ) where the panes meet.
Selecting Your Kits

1.Measure the height and width of your window opening

2.Select a Width Kit which exceeds the width of your window opening by at least 32mm (1 1/4″ ).

3.Select a Height Kit which exceeds the height of your window opening by at least 32mm (1 1/4″ ).

4.You will also need an Accessory Kit for each pane.

5.The maximum pane size is 12sq.ft when side hinged, 18sq.ft. when top hinged.

Installation Instruction Downloads

DIY secondary glazing Horizontal Sliding Pane Kits

The DIY secondary glazing  horizontal sliding system is available in either aluminium or quality uPVC kits.

The DIY secondary glazing  horizontal sliding system makes up to give two panes which may be of equal or unequal size to match your existing window layout. The basic two-pane system may be extended to three or more panes by using one multi-pane kit for each additional pane.

The panes slide smoothly in tracks which are fitted to the window recess. There should be a flat area of at least 42mm ( 1 11/16″ ) all round to accept the tracks. The system is sutable for windows up to 8 feet wide by 6 feet high, but no single pane should exceed the following sizes for 4mm glass or acrylic and 2mm acrylic.

Selecting Your Kits

1. Measure the height and width of your window recess.
2. For 2 Sliding panes choose 1 x Height Kit and 1 x Width Kit to the nearest longer size.
3. For 3 or more sliding panes select 1 x Multi-Pane Kit for each additional pane.
4. The kit contains accessories and step-by-step instructions.
5. Select your glazing material after you have installed the outer tracks and taken precise measurements from them. Each single frame should not exceed 20sq. ft.

uPVC Kits

Aluminium Kits

DIY secondary glazing kits Vertical Sliding Pane Kits

DIY secondary glazing kits Vertical Sliding Pane Kits  is specially designed for traditional sash windows, but is ideal for any window where top or bottom access is required.
As with the vertical sliding System the panes may be of equal or unequal size to match your window layout.
The panes are held open when required by an ingenious system of ratchets which support the pane in any position. The vertical sliding system is suitable for windows up to 8 feet high or 4 feet wide but no single pane should exceed 12sq.ft in area.

It is normally fitted to the inside of the window recess. If, however , you have no suitable recess, the system may also be fitted directly to the flat wooden surface of the window surround. In either case there should be a minimum flat area of at least 42mm (1 11/16″ ) to accept the tracks.

Selecting Your Kits
1.Measure the height and width of your window recess.

2.Choose 1 x Height Kit and 1 x Width Kit to the nearest longer size.

3.The kit contains accessories and step-by-step instructions.

4.Select your glazing material after you have installed the outer tracks and taken precise measurements from them. Each single frame should not exceed 20sq. ft.

Installation Instruction Downloads